3-56
Instruments and controls/Light control switch
& Headlight flasher
& Daytime running light system
S03AH03
S03AH04
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the “ ” position when it
is dark outside.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works even
though the lighting switch is in the off
position.
When the headlights are on high beam, the
high beam indicator light “ ” on the
combination meter also illuminates.
The high beam headlights will automati-
cally illuminate at reduced brightness
when the engine has started, under the
following conditions.
. The parking brake is fully released.
. The light switch is in the off or “
”
position.
. The light switch is in the “AUTO”
position and the headlights do not turn on
automatically.
. The select lever is in a position other
than the “P” position.
NOTE
. When the light switch is in the “
”
position, the front side marker lights,
tail lights and license plate lights are
illuminated.
. While the turn signal is flashing, the
high beam headlight on the side which
the turn signal is flashing turns off.
. While the hazard warning flasher is
on, the high beam headlights turn off.