130
Alarm System
If the following actions are not performed within 10 minutes, while the function is in standby mode, any room lights that are on will automatically turn off.
Turning off lights
Actions
– Map light – Dome light – Ignition switch light * 1 – Cargo area light – Vanity mirror light * 3
– Turn the ignition switch to the“ ACC” or“ ON” position.
– Open or close the doors, including the rear gate.
– Push the unlock button on the access key fob or transmitter.
– Hold the front door handle and unlock it while holding the access key fob.* 1
– Insert the key into the keyhole of the ignition switch.* 2
– Come close to the vehicle that the front door was locked while holding the access key fob( if OFF delay timer setting for period of time is not off).* 1 – Push the panic button on the access key fob or transmitter.
* 1: Models with“ keyless access with pushbutton start system”
* 2: Models without“ keyless access with pushbutton start system” * 3: If equipped Perform the action in the above table to illuminate the lights again when the battery drainage reduction function is active.
NOTE
. The battery drainage reduction function cannot be turned off.
. If the battery drainage reduction function is in operation when a door is open, the target room light will not be illuminated.
. To protect the battery from battery drainage, make sure that all doors, including the rear gate, are completely closed when leaving the vehicle.
2-6. Alarm System s02af
The alarm system helps to protect your vehicle and valuables from theft. The horn sounds and the hazard warning flashers flash if someone attempts to break into your vehicle.
For models with“ keyless access with push-button start system”:
The system can be armed or disarmed with the keyless access function or access key fob.
The system will not be activated when the push-button ignition switch is in the“ ACC” or“ ON” position.
For models without“ keyless access with push-button start system”:
The system can be armed or disarmed with the remote transmitter.
The system will not be activated when the key is inserted into the ignition switch.
Your vehicle’ s alarm system has been set for activation at the time of shipment from the factory. You can set the system for deactivation yourself or have it done by your SUBARU dealer.