Seatbelts 47
2. Insert a center seatbelt tongue plate or other hard pointed object into the slot in the anchor buckle on the right-hand side and push it in. The anchor tongue plate will then disconnect from the buckle.
3. Allow the retractor to roll up the belt. You should hold the webbing end and guide it back into the retractor while it is rolling up. Then, pass the webbing under the belt holder and insert the anchor tongue plate into the holder.
CAUTION
Observe the following precautions. Otherwise, the tongue plate can hit against the trim, causing damage to the trim.
. Do not allow the retractor to roll up the seatbelt too quickly.
. Have the seatbelt fully rolled up so that the tongue plates are neatly stored.
1
Seat, Seatbelt and SRS Airbags
– CONTINUED –