150
Hazard Warning Flasher
locked. When this occurs, press the push-button ignition switch while turning the steering wheel left and right.
! Battery drainage reduction function s03bg0201
When the push-button ignition switch is left in the“ ACC” position for approximately 20 minutes or the“ ON” position( the engine is not running) for approximately 1 hour, the push-button ignition switch will be automatically switched to“ OFF” to reduce the possibility of the battery going dead.( This function is activated when the select lever is in the“ P” position.)
& When Access Key Fob Does Not Operate Properly s03bg03
Refer to“ Access Key Fob – If Access Key Fob Does Not Operate Properly” FP426.
3-3. Hazard Warning Flasher s03ab
The hazard warning flasher is used to warn other drivers when you have to park your vehicle under emergency conditions. The hazard warning flasher works with the ignition switch in any position.
To turn on the hazard warning flasher, press the hazard warning flasher switch on the instrument panel. All the turn signal lights and the turn signal indicator lights will flash. To turn off the flasher, press the switch again.
NOTE
When the hazard warning flasher is on, the turn signals do not work.
3-4. Meters and Gauges s03ad
NOTE
Liquid crystal displays are used in some of the meters and gauges in the combination meter. You will find their indications hard to see if you wear polarized glasses.
& Speedometer s03ad03
The speedometer shows the vehicle speed.
NOTE
The initial movement of the meter needles and gauge needles that occurs when the ignition switch is turned to the“ ON” position can be activated or deactivated.
For details, refer to“ General settings” FP196( 11.6-inch display models) or“ General settings” FP213( dual 7.0- inch display models).