Alarm System 133 |
|||||||||||
|
out“ keyless access with pushbutton start system”).
– Push-button ignition switch is turned to the“ ACC” position( models with“ keyless access with push-button start system”).
& Disarming the System s02af05
Perform either of the following procedures.
. Briefly press an unlock button( for less than 2 seconds) on the access key fob / remote transmitter.
. Carry the access key fob and perform either of the following procedures( models with“ keyless access with push-button start system”). – Grip the front door handle. – Press the rear gate opener button. – Unlock using the PIN code access.
The flashing of the security indicator light will then change slowly( once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed.
! Emergency disarming s02af0501
If you cannot disarm the system using the access key fob / transmitter( i. e., the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the access key fob /
|
remote transmitter.
The system can be disarmed if you turn the ignition switch from the“ LOCK”/“ OFF” position to the“ ON” position with a registered key / access key fob.
NOTE
For models with“ keyless access with push-button start system”, if the access key fob battery is discharged, perform the procedure described in“ Switching Power Status” FP426. In such a case, replace the battery immediately. Refer to“ Replacing Battery of Access Key Fob” FP486.
|
& Alarm System Setting s02af11
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to“ Disarming the System” FP133.
2. Sit in the driver’ s seat and shut all doors, the rear gate and engine hood.
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed
|
as follows.
Setting status
Combination meter display( color LCD)
Horn
NOTE
You may have the above setting change done by your SUBARU dealer.
& If You Have Accidentally Triggered the Alarm System
s02af03
! To stop the alarm s02af0301
Do any of the following operations:
. Press any button on the access key fob / remote transmitter.
. Turn the ignition switch to the“ ON” position( models without“ keyless access with push-button start system”).
. Turn the push-button ignition to the“ ACC” position( models with“ keyless access with push-button start system”).
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.
|
2
Keys and Doors
|
|||||||
– CONTINUED – |