Instruments and controls / Light control switch 3-69
& High beam assist function( if equipped)
S03AH07
NOTE
. The high beam assist function utilizes the stereo camera installed at the position of the front map lights.. For details on how to handle the stereo camera, refer to the Owner’ s Manual supplement for the EyeSight system.
The high beam assist function automatically changes the headlight from high beam to low beam( or vice versa).
When all of the following conditions are met, the headlight will change to high beam.
. When the vehicle speed increases to or above 20 mph( 32 km / h).
. There is no preceding or oncoming vehicle.
. The forward area of the vehicle is dark.. The road does not have a sharp curve.
When any of the following conditions is met, the headlight will change to low beam.
. When the vehicle speed decreases to or below 10 mph( 16 km / h).
. When the forward area of the vehicle is bright.
. When there is a preceding or oncoming vehicle.
. When the EyeSight system is malfunctioning or is temporarily stopped.
NOTE
The factory setting( default setting) for this function is set as“ operational”. This setting can be changed to OFF( non-operation) at SUBARU dealers. For more details, contact a SUBARU dealer.
! How to use the high beam assist function
S03AH0701
The high beam assist function will be activated when all the following conditions are met.
. The light control switch is in the“ AUTO” position and the low beam headlights are on automatically.
. The turn signal lever is pushed forward.
High beam assist indicator
When the high beam assist function is activated, the high beam assist indicator light( green) on the combination meter will illuminate.
NOTE
If the high beam assist function is malfunctioning or is temporarily stopped, the headlight will be fixed at low beam.
– CONTINUED –