3-8
Instruments and controls/Hazard warning flasher
does not operate smoothly, stop
the operation. Contact a
SUBARU dealer immediately.
. If the push-button ignition switch
does not illuminate even when
the instrument panel illumination
is turned on, have the vehicle
inspected at a SUBARU dealer.
. If the vehicle was left in the hot
sun for a long time, the surface of
the push-button ignition switch
may get hot. Be careful not to
burn yourself.
NOTE
. The push-button ignition switch cannot be switched to “OFF” when the
select lever is in a position other than
“P”.
. When operating the push-button
ignition switch, firmly press it all the
way.
. If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
. If the indicator light on the pushbutton ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
Hazard warning flasher
! Battery drainage prevention function
When the push-button ignition switch is
left in the “ACC” or “ON” position for
approximately 1 hour, the push-button
ignition switch will be automatically
switched to “OFF” to prevent the battery
from going dead. This function is activated
when the select lever is in the “P” position.
& When access key does not
operate properly
Refer to “Access key – if access key does
not operate properly” F9-18.
Models without multi function display
Models with multi function display
The hazard warning flasher is used to
warn other drivers when you have to park