Instruments and controls/Multi function display
2. Operate the “ ” or “ ” switch to
select the “Hazard Warning Flasher” item.
Then push the
button.
4. Select “On” or “Off” by operating the
“ ” or “ ” switch. Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection
mode.
3-81
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pushing
the
button.
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
– CONTINUED –