3-80
Instruments and controls/Multi function display
push the
button.
3. The current setting will be displayed.
button to enter the selection
Push the
mode.
button.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pushing
the
button.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Hazard warning flasher setting
1. Perform the preparation steps according to “Preparation for car settings” F3-78.
4. Select “On” or “Off” by operating the
“ ” or “ ” switch. Then push the
6. The system will notify you that the
setting is complete.