IN CASE OF EMERGENCY 461
the SRS airbag system in a frontal collision.
3. Screw the towing hook into the threaded hole until its thread can no longer be seen.
CAUTION
To prevent deformation to the bumper and the towing hook, do not apply an excessive load to the towing hook.
Rear towing hook s09af0105
1. Take out the screwdriver, towing hook, wheel nut wrench and jack handle from storage area of the vehicle. For the tool storage locations, refer to“ Maintenance Tools” FP446.
2. Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch the bumper. Insert the flathead screwdriver into the cutout of the cover and pry open the cover.
S _ 901443-W
4. Tighten the towing hook securely using the jack handle and wheel nut wrench.
9
S _ 901635-W
S _ 901442-W
After towing, remove the towing hook from the vehicle and stow it in the underfloor storage compartment.
Fit the towing hook cover on the bumper.
Store the screwdriver, towing hook, wheel nut wrench and jack handle in their storage locations.
WARNING
. Do not use the towing hook for purposes other than towing your vehicle.
. Be sure to remove the towing hook after towing. Leaving the towing hook mounted on the vehicle could interfere with proper operation of
– CONTINUED –