SEAT, SEATBELT AND SRS AIRBAGS 43
4. Turn the ignition switch to the“ OFF” position.
5. Hold the access key fob and press and hold the“ SET” button, then press the“” button of the access key fob.
A chirp will sound once to signal that the following items were registered.
. Driver’ s seat position. Both outside mirrors’ angles
. Reverse tilt-down mirror angles( passenger’ s side only)
NOTE
. The factory setting( default setting) for this function is set as the front passenger’ s side mirror. The setting of the right and left side mirror / front passenger’ s side mirror operation can be changed by a SUBARU dealer. Contact your SUBARU dealer for details.
. The system stores the adjusted mirror angle for approximately 45 seconds after the ignition switch is turned to the“ OFF” position. Register the mirror angle while the memory function is available.
Retrieval of memory position registered with button“ 1” or“ 2” s01aa0305
WARNING
Be sure to press the correct button to retrieve your registered seat position. If the seat position is not optimum for you, it may adversely affect your driving and may reduce the effectiveness of the seatbelt. That could result in an accident involving serious injury or death.
S _ 103157-W
A chirp will sound and the seat and outside mirror move to the registered position.
When the select lever is moved to the“ R” position, the outside mirror will move to the registered reverse tilt-down position.
NOTE
. If the vehicle battery is removed, the registered memory position data will not be deleted.
. When the button“ 1” or“ 2” is pressed within 45 seconds after the driver’ s door is opened, the registered memory position can be retrieved even if the ignition switch is in the“ OFF” position.
. If buttons“ 1” and“ 2” are pressed at the same time, execution of seat position retrieval may not be possible.
. When the retrieved position is the same as the current seat position, a chirp will sound twice.
Retrieval of the memory position registered with access key fob s01aa0306
1. Hold the registered access key fob.
1
1. Turn the ignition switch to the“ ON” position.
2. Put the select lever is in the“ P” position and apply the parking brake, then press button“ 1” or“ 2”.
– CONTINUED –