SEAT, SEATBELT AND SRS AIRBAGS 41
– Operate any of the power seat switches.
– Press the“ SET” button. – Press button“ 1” or“ 2”.
– Operate the outside mirror control switch.
. While pressing and holding the“ SET” button, press either“ 1” or“ 2” until a chirp sounds within 5 seconds.
1
Some seat positions can be registered. Register the seat position with button“ 1” or“ 2” or each of the key fobs and retrieve the seat position.
The following seat positions can be registered.
. Forward / backward position of the seat. Angle of the seatback. Angle of the seat cushion. Height of the seat. Angle of the outside mirrors
. Angle of the outside mirrors while the vehicle is in reverse
NOTE
The seat position can also be retrieved with the Driver Monitoring System user information. To do so, perform user registration in the Driver Monitoring System settings. Refer to“ Using the Driver Monitoring System” FP417.
Registration of memory position with button“ 1” or“ 2” s01aa0301
1. Adjust the seat position under the following conditions.
. The parking brake is applied.
. The ignition switch is in the“ ON” position.
. The select lever is in the“ P” position.
2. Register the adjusted positions by either of the following procedures.
. Press the“ SET” button, then press either“ 1” or“ 2” until a chirp sounds within 5 seconds.
S _ 103155-W
A chirp will sound once to signal that the following items were registered.
. Driver’ s seat position. Both outside mirrors’ angles
. Reverse tilt-down mirror angles( passenger’ s side only)
NOTE
If a new position is registered for the same button, the previously registered memory position is deleted.
Registration of the reverse tiltdown mirror angle with button“ 1” or“ 2” s01aa0302
CAUTION
Depress the brake pedal when registering the reverse tilt-down mirror angle.
1. Move the select lever to the“ R” position, then the outside mirror angle will move to the reverse tilt-down position.
2. Adjust the outside mirror angle. For details about the settings, refer to“ Remote control mirror switch” FP269.
– CONTINUED –