KEYS AND DOORS 147
. Continuously operating three or more switches all at once in the same direction after the windows are fully closed or fully opened.
Either of the operations described above may cause the power window breaker to operate making it impossible to open or close the window. Be sure to initialize the power windows. Refer to“ Initialization of Power Window( Windows with One- Touch Auto Up and Down Function)” FP147.
Anti-entrapment function( windows with one-touch auto up and down function) s02ah1001
While closing the window automatically, if the window senses a substantial enough object trapped between the window and the window frame, it automatically moves down slightly and stops.
If a foreign object is caught while window is opening automatically, the window will stop.
CAUTION
. Never attempt to test the power window operation using body parts.
. If an object is caught just before the window fully closes, the system may not operate properly.
NOTE
. If a window detects an impact similar to that caused by trapping an object( for example, when the vehicle encounters a deep pothole), the antientrapment function may operate.
. You cannot close the window for a few seconds after the anti-entrapment function operates.
Off delay function( windows with one-touch auto up and down function) s02ah1002
The windows can be operated for approximately 40 seconds even after the ignition switch is turned to the“ ACC” or“ LOCK”/“ OFF” position. If a front door is opened within 40 seconds, the off delay function is canceled.
LOCKING THE PASSENGERS’ WINDOWS s02ah11
Lock Unlock
S _ 204487-MW
When the lock switch is in the lock position, the rear passenger’ s window switches on the driver side door and the passengers’ window switches cannot be operated.
When the indicator on the window switches does not illuminate, the window switch cannot be operated.
INITIALIZATION OF POWER WINDOW( Windows with One- Touch Auto Up and Down Function) s02ah06
If the one-touch auto up and down function or off delay function does not operate properly, operate each window according to the following procedure in order to initialize the power window system.
2
– CONTINUED –