KEYS AND DOORS 135
S _ 204381-MW
Steps Operation Time
3
1 Sit in the driver ’ s seat . — 2 Close all doors . —
4
( 1 )
( 2 )
Press and hold “ ” on the power locking switch .
Insert the key into the ignition switch and pull it out at least 6 times .
Open and close the driver ’ s door .
Within 10 sec .
Within 10 sec .
The hazard warning flashers flash 3 times to indicate completion of the setting .
Your SUBARU dealer can perform the above procedure for you .
SELECTING HAZARD WARN- ING FLASHER OPERATION s02ae26
Using the hazard warning flasher , the system will give you a visible signal when the doors are locked or unlocked . If desired , you can turn the hazard warning flashers off by operating the center information display . For details , refer to the following sections .
– “ Car settings icon ” FP216 ( dual 7.0- inch display models )
– “ Settings icon ( Car settings )” FP231 ( 11.6-inch display models )
The setting can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
VEHICLE FINDER FUNCTION s02ae05
Use this function to find your vehicle parked among many vehicles in a large parking lot . Provided you are within 30 feet ( 10 meters ) of the vehicle , pressing the “ ” button three times in a 5-second period will cause your vehicle ’ s horn to sound once and its hazard warning flashers to flash three times .
NOTE
If the interval between presses is too short when you press the “ ” button three times , the system may not respond to the signals from the remote transmitter .
SOUNDING A PANIC ALARM s02ae06
To activate the alarm , press the PANIC button once .
The horn will sound and the hazard warning flashers will flash .
To deactivate the panic alarm , press any button on the access key fob / transmitter . If a button on the access key fob / transmitter is not pressed , the alarm will be deactivated after approximately 30 seconds .
REPLACING THE BATTERY s02ae08
Refer to “ Replacing Battery ” FP526 .
REPLACING LOST TRANSMIT- TERS s02ae09
If you lose a transmitter or want to purchase additional transmitters ( up to four can be programmed ), you should reprogram all your transmitters for security reasons . For details , contact your SUBARU dealer and have the transmitters programmed into the remote keyless entry system .
2
– CONTINUED –