IN CASE OF EMERGENCY 453
CAUTION
To prevent deformation to the bumper and the towing hook, do not apply an excessive load to the towing hook.
4. Tighten the towing hook securely using the jack handle and wheel nut wrench.
Rear towing hook s09af0105
1. Take out the screwdriver, towing hook, wheel nut wrench and jack handle from the under-floor storage compartment.
2. Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch the bumper. Insert the flathead screwdriver into the cutout of the cover and pry open the cover.
S _ 901442-W
3. Screw the towing hook into the threaded hole until its thread can no longer be seen.
S _ 901635-W
After towing, remove the towing hook from the vehicle and stow it in the underfloor storage compartment.
Fit the towing hook cover on the bumper.
WARNING
. Do not use the towing hook for purposes other than towing your vehicle.
. Be sure to remove the towing hook after towing. Leaving the towing hook mounted on the vehicle could interfere with proper operation of the fuel pump shut off function when the vehicle is struck from behind.
9
CAUTION
. To prevent deformation to the bumper and the towing hook, do not apply an excessive load to the towing hook.
S _ 901443-W
– CONTINUED –