! Memory function |
Memory switch |
S02AJ0101 |
Your desired rear gate height can be registered .
Registration of the rear gate height :
To register the rear gate height , perform the following procedures .
1 . Open the rear gate using the power rear gate function .
2 . With the rear gate at the desired height , stop it using the power rear gate function .
3 . Press the memory switch to select the “ ON ” status .
|
gate button on the inside edge of the rear gate until an electronic chirp is heard and the hazard warning flashers flash three times . The electronic chirp and the flashing hazard warning flashers confirm the selected rear gate height has been registered .
NOTE
. To change the registered height , press the memory switch to select the “ OFF ” status and perform the registering procedure again .
. It is possible to register the height from approximately 2 in ( 5 cm ) or more from the completely closed position .
|
||||
Memory switch status 1 ON status 2 OFF status |
Power rear gate button on the inside edge of the rear gate
1 Power rear gate button 2 Power rear gate lock button
4 . With the rear gate at the desired height , press and hold the power rear
|
Retrieval of the rear gate height :
To open the rear gate and stop it at the registered height , perform the following procedure .
1 . Press the memory switch to select the ON status .
2 . Press and hold any of the power rear gate switches .
Even if any of the power rear gate switches are pressed and held while the memory switch is in the OFF status , you can stop it at the registered height by pressing the memory switch to select the ON status
|