148
Rear gate
hazard warning flashers will flash twice .
If you press the power rear gate button again , the rear gate will close .
You can open the rear gate by pressing the power rear gate button briefly while the rear gate is being closed .
NOTE
The rear gate cannot be paused when it is in the approximately 2 in ( 5 cm ) range from the fully closed position . The system will ignore any button operation and the rear gate will continue to open .
To close the rear gate :
Press and hold the power rear gate button . Then an electronic chirp will sound twice and the hazard warning flashers will flash twice . If you briefly press the power rear gate button again , the rear gate will open .
NOTE
The factory setting ( default setting ) of the operation for the “ ” button on the access key fob or the transmitter is pressing and holding . This setting can be changed to non-operation or pressing twice at SUBARU dealers . For more details , contact a SUBARU dealer .
! By the buttons on the rear gate
S02AJ011102
NOTE
After performing the following procedures , an electronic chirp will sound twice and the hazard warning flashers will flash twice .
Rear gate opener button
Power rear gate button on the inside edge of the rear gate
1 Power rear gate button 2 Power rear gate lock button
To open the rear gate :
1 . For models with “ keyless access with push-button start system ”, carry the access key fob . For models without “ keyless access with push-button start system ”, unlock the rear gate .
2 . Briefly press the rear gate opener button when the rear gate is closed .
The rear gate will open automatically .
To pause the opening rear gate :
Briefly press either of the following buttons while the rear gate is being opened .
. Rear gate opener button