|
9-9 . Rear gate – if the rear gate cannot be opened
S09AG
In the event that you cannot open the rear gate by operating the rear gate opener button , you can open it from inside the cargo area .
|
CAUTION
Never operate the rear gate open lever with fingers because doing so may cause an injury . Always use a flat-head screwdriver or a similar tool .
|
||||
|
4 . Hold the access key fob with the buttons facing you , and touch the push-button ignition switch with it . When the communication between the access key fob and the vehicle is completed , a chime ( ding ) will sound . At the same time , the push-button ignition switch turns to the “ ACC ” or “ ON ” position .
5 . After the push-button ignition switch turns to the “ ACC ” or “ ON ” position , while depressing the brake pedal , press the push-button ignition switch .
NOTE
If the engine does not start even though the above procedure was followed precisely , contact your SUBARU dealer .
|
1 . Remove the access cover at the bottom-center of the rear gate trim using a flat-head screwdriver wrapped with vinyl tape or a cloth .
2 . Locate the rear gate open lever behind the rear gate trim .
|
Models without power rear gate |
In case of emergency |
||
– CONTINUED – |