122
Keyless access with push-button start system
lock sensor . – Lock or unlock the doors using the remote keyless entry system . – Lock or unlock the doors using the power door locking switch . – Open either of the front doors .
& Power saving function of access key fob
S02AP22
This function stops the access key fob from receiving signals and helps minimize the battery consumption of the access key fob .
1 . Press the “ ” button twice while holding the “ ” button .
1 LED indicator
2 . Confirm that the LED indicator blinks 4 times to notify that the setting is complete .
When the access key fob is in the power save mode , the keyless access function and push-button start system will not be available .
To cancel the power save mode , press one of the buttons on the access key fob .
& Disabling keyless access function
S02AP07
WARNING
If you wear an implanted pacemaker or an implanted defibrillator , perform the procedure described in “ By operating the driver ’ s door ” FP123 to disable the keyless access function . If you perform the procedure described in “ By operating the access key fob ” FP122 , the operation of an implanted pacemaker or implanted defibrillator may be affected by the radio waves from the transmitter antenna .
When the vehicle is not going to be used for a long time or when you choose not to use the keyless access function , the keyless access function can be disabled .
NOTE
. The locking and unlocking function by the remote keyless entry system is not disabled .
. To start the engine while the functions are disabled , perform the procedure described in “ Starting engine ” FP434 .
! Disabling functions
S02AP0701
! By operating the access key fob
S02AP070102
If you have registered a PIN code for PIN Code Access , you can disable the keyless access function by operating the access key fob . For details about registering a PIN code , refer to “ Unlock using PIN Code Access ” FP119 .
1 . Open the driver ’ s door .
2 . Rotate the lock lever toward the lock position .