Replacing bulbs
479
4. Replace the bulb. At this time, use care
not to touch the bulb surface.
5. To install the bulb to the headlight
assembly, turn it clockwise until it clicks.
6. Reconnect the electrical connector.
7. Put the air intake duct with the clips
(right-hand side).
8. Set the washer fluid filler pipe to the
original place and secure it with the clips
(left-hand side).
& Front position light (if
equipped)
S11BE56
The bulbs of the front position lights are the
same as the front turn signal lights. Refer
to “Front turn signal light” FP478 for the
replacement order.
Left-hand side
2. Use a screwdriver to remove the
secured clip of the washer tank. To make
it easy to access the bulb, turn the neck of
the washer fluid filler pipe as illustrated.
Type B
3. Disconnect the electrical connector
from the bulb and remove the bulb from
the headlight assembly by turning it
counterclockwise.
– CONTINUED –
Type A