Keyless access with push-button start system
! How to lock and unlock
S02AP2002
It is possible to perform the following
operations when you are carrying the
access key fob.
. Lock and unlock the doors
. Unlock and lock rear gate
NOTE
. It is not possible to lock the doors,
rear gate and fuel lid using the keyless
access function when the push-button
ignition switch is in the “ACC” or “ON”
position. Refer to “Switching power
status” FP159.
. If the door handle is gripped with a
gloved hand, the door lock may not be
released.
. If the door lock sensor is touched
three times or more repeatedly, the
system will ignore the sensor opera-
tion.
. When performing the locking proce-
dure too quickly, locking may not
complete. After performing the locking
procedure, it is recommended to pull
the REAR door handle to confirm that
the doors have been locked.
. If any of the doors (or the rear gate)
are not fully closed, the following will
occur to alert you that the doors (or the
rear gate) are not properly closed.
– An electronic chirp sounds five
times.
– The hazard warning flashers
flash five times.
. It is possible to lock the doors even
when one of the doors is open. After
performing the locking procedure,
close the opened door or rear gate to
lock it.
. Within 3 seconds after locking the
doors and the rear gate using the
keyless access function, it is not pos-
sible to unlock doors and/or the rear
gate using the keyless access function.
. When locking, be sure to carry the
access key fob to prevent locking the
access key fob in the vehicle.
. The setting of the hazard warning
flasher operation and the volume of the
audible signal can be changed by your
SUBARU dealer. Contact your SUBARU
dealer for details. Also, for models with
the combination meter display (color
LCD), the setting of the hazard warning
flasher operation can be changed by
operating the combination meter dis-
play (color LCD). For details, refer to
“Keyless Entry System” FP196.
! Locking with the door lock sensor
S02AP200201
1)
Door lock sensor
Carry the access key fob, close all doors
including the rear gate, and touch the door
lock sensor on the door handle. All doors
including the rear gate and fuel lid will be
locked. Also, an electronic chirp will sound
once and the hazard warning flashers will
flash once.
– CONTINUED –
described in “Locking and unlocking”
FP429.
. The doors may lock or unlock when
the car is being washed or exposed to a
significant amount of water that con-
tacts the door handle while the key fob
is still in the operating range.
115