114
Keyless access with push-button start system
& Locking and unlocking by
holding the access key fob
S02AP20
When the access key fob is carried within
the operating range, the doors, rear gate
and fuel lid can be locked/unlocked just by
touching the door handle.
NOTE
The vehicle can also be locked/un-
locked with the remote keyless entry
system. For details, refer to “Remote
keyless entry system” FP127.
1)
! Operating ranges
S02AP2001
LED indicator
When the access key fob is within either of
the operating ranges of the front doors, the
LED indicator on the access key fob
flashes. When the keyless access func-
tions are disabled, the LED indicator does
not flash unless a button on the access key
fob is pressed.
NOTE
1)
2)
Antenna
Operating range (approximately 16 to 32
in (40 to 80 cm))
. If the access key fob is placed too
close to the vehicle body, the keyless
access functions may not operate
properly. If it does not operate properly,
repeat the operation from farther away.
. If the access key fob is placed near
the ground or in an elevated location
from the ground, even if it is in the
indicated operating range, the keyless
access function may not operate prop-
erly.
. When the access key fob is within
the operating range, it is possible for
anyone, even someone who is not
carrying the access key fob, to operate
the keyless access function. Note that
the keyless access function can be
operated only by the door handle, door
lock sensor, rear gate opener button or
rear lock button in the operating range
in which the access key fob is detected.
. It is not possible to lock the doors,
rear gate and fuel lid using the keyless
access function when the access key
fob is inside the vehicle. However,
depending on the status of the access
key fob and the environmental condi-
tions, the access key fob may be locked
inside the vehicle. Before locking the
vehicle, make sure that you have the
access key fob.
. When the battery of the access key
fob is discharged, or when operating it
in a location with strong radio waves or
noise (e.g., near a radio tower, power
plant, broadcast station or an area
where wireless equipment is used), or
while talking on a cell phone, the
operating ranges may be reduced, or
the keyless access function may not
operate.
In such a case, perform the procedure