Subaru Forester Manuals 2017 Forester Owner's Manual | Page 475

7-72 Starting and operating/Reverse Automatic Braking System NOTE Automatic braking by the system will be released 2 seconds after the vehicle has been stopped. Before the automatic brake is released, a warning sound (3 short beeps followed by a long beep) will activate to alert the driver. & Canceling the Reverse Automatic Braking system operation 4) After the vehicle has been stopped by the system: Make sure to depress the brake pedal after the vehicle has been stopped by automatic braking. Until the brake pedal is depressed, a message will be displayed on the multi function display and the continuous beep will remain sounding. After the brake pedal is depressed, the Reverse Automatic Braking system OFF indicator will illuminate and the system will temporarily stop operating. The Reverse Automatic Braking system OFF indicator will turn off when the select lever is shifted to a position other than the “R” position. The system will operate again the next time the select lever is shifted to “R” position. The Reverse Automatic Braking system can be temporarily cancelled by any of the following operations. . While automatic braking is in operation, the brake pedal is depressed . While automatic braking is in operation, the accelerator pedal is depressed . When automatic deceleration is in activation, the accelerator pedal is depressed hard . The select lever is shifted to a position other than the “R” position & Reverse Automatic Braking system ON/OFF setting While the select lever is shifted to the “R” position, the below functions of the Reverse Automatic Braking system can be set by operating the multi function display. For details about how to operate the multi function display, refer to “Basic operation” F3-45. 1) 2) ON/OFF setting of Reverse Automatic Braking ON/OFF setting of the object detection warning sound NOTE The system will be cancelled if the object is no longer detected. NOTE The Reverse Automatic Braking system settings that are changed by the multi function display will be restored to default (ON setting) the next time the