Light Control Switch 233 |
||||
|
. The locking procedure is performed twice. When performing the unlocking procedure after performing the locking procedure, perform the locking procedure twice again.
* 1: The setting for the period of time in which the low beam headlights remain on by the welcome lighting function can be changed by a SUBARU dealer. Contact your SUBARU dealer for details. Also, you can change the setting by operating the center information display. For details, refer to“ Car settings” FP202( 11.6-inch display models) or“ Vehicle setting icons” FP220( dual 7.0- inch display models).
! Battery drainage reduction function s03ah0107
When the headlights are illuminated under the following conditions, the battery drainage reduction function will be active.
. The push-button ignition switch is turned to the“ OFF” status( models with“ keyless access with push-button start system”).
. The key is pulled out from the ignition switch( models without“ keyless access with push-button start system”).
|
. The headlights turn off automatically after 10 minutes.
. When you open or close the door or operate the light control switch, the headlights will turn off automatically 10 minutes later.
NOTE
. When you leave the vehicle, put the light control switch in the“ OFF” position to prevent battery discharge.
. When you open or close the door or operate the light control switch after the headlights turn off automatically, the headlights will turn on again.
|
! Sensor for the auto on / off headlights s03ah0101 |
The sensor is on the dashboard as shown in the illustration.
CAUTION
If any object is placed on or near the sensor, the sensor may not detect the level of the ambient light correctly and the auto on / off headlights may not operate properly.
|
3
Instruments and Controls
|
When the battery drainage reduction function is active, the following system operations help reduce the risk of battery discharge. |
||||
– CONTINUED – |