232
Light Control Switch
. The light sensitivity of the auto on / off headlights can be changed by operating the center information display. For details, refer to“ Car settings” FP202( 11.6-inch display models) or“ Vehicle setting icons” FP220( dual 7.0-inch display models). Also, the setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
“” position:
Instrument panel illumination, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are on.
“” position:
Instrument panel illumination, headlights, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are on.
! Auto-on / off wiper-linked headlights s03ah0106
While the light control switch is in the“ AUTO” position, the headlights will automatically turn on when the windshield wipers operate several times. The headlights will automatically turn off approximately 1 minute after the wiper stops.
The ON / OFF setting of this function can be changed by operating the center information display. For details, refer to“ Car settings” FP202( 11.6-inch display models) or“ Vehicle setting icons” FP220( dual 7.0-inch display models). Also, the setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
! Welcome lighting function s03ah0103
The welcome lighting function turns on the low beam headlight for smooth approaching to or exiting from the vehicle at night or in a dark place.
The function is activated while all of the following conditions are met.
. The light control switch is in the“ AUTO” position.
. It is dark enough to turn on the auto on / off headlights.
NOTE
If the engine is turned off after turning off the light switch, the welcome lighting function may not operate( for Canada models).
! When approaching s03ah010301
While the welcome lighting function is activated, the low beam headlights will automatically illuminate when unlocking the doors by using the remote keyless entry system.
The low beam headlights will remain illuminated for 30 seconds * 1 and then turn off. However, if any of the following operations is done, the low beam headlights will turn off.
. The doors are locked.
. The light control switch is turned to a position other than“ AUTO”.
! When exiting s03ah010302
While the welcome lighting function is activated, the low beam headlights will remain illuminated even when either of the following operation is done.
. The push-button ignition switch is turned to the“ OFF” status( models with“ keyless access with push-button start system”).
. The key is pulled out from the ignition switch( models without“ keyless access with push-button start system”).
The low beam headlights will turn off under any of the following conditions.
. 3 minutes have passed since the low beam headlights were illuminated by the welcome lighting function.
. 30 seconds have passed since the door is opened and closed.* 1
. The light control switch is turned to a position other than“ AUTO”.