150
Hazard Warning Flasher
locked . When this occurs , press the push-button ignition switch while turning the steering wheel left and right .
! Battery drainage reduction function s03bg0201
When the push-button ignition switch is left in the “ ACC ” position for approximately 20 minutes or the “ ON ” position ( the engine is not running ) for approximately 1 hour , the push-button ignition switch will be automatically switched to “ OFF ” to reduce the possibility of the battery going dead . ( This function is activated when the select lever is in the “ P ” position .)
& When Access Key Fob Does Not Operate Properly s03bg03
Refer to “ Access Key Fob – If Access Key Fob Does Not Operate Properly ” FP442 .
3-3 . Hazard Warning Flasher s03ab
The hazard warning flasher is used to warn other drivers when you have to park your vehicle under emergency conditions . The hazard warning flasher works with the ignition switch in any position .
To turn on the hazard warning flasher , press the hazard warning flasher switch on the instrument panel . All the turn signal lights and the turn signal indicator lights will flash . To turn off the flasher , press the switch again .
NOTE
When the hazard warning flasher is on , the turn signals do not work .
3-4 . Meters and Gauges s03ad
NOTE
Liquid crystal displays are used in some of the meters and gauges in the combination meter . You will find their indications hard to see if you wear polarized glasses .
& Speedometer s03ad03
The speedometer shows the vehicle speed .
NOTE
The initial movement of the meter needles and gauge needles that occurs when the ignition switch is turned to the “ ON ” position can be activated or deactivated .
For details , refer to “ General settings ” FP197 ( 11.6-inch display models ) or “ General settings ” FP214 ( dual 7.0- inch display models ).