Subaru Crosstrek Manuals 2025 Crosstrek Owner's Manual | Page 133

Remote Keyless Entry System 125
Steps
Operation
Time
1
Sit in the driver ’ s seat .
2
Close all doors .
( 1 )
Press and hold “
” on the power locking
switch .
3
4
( 2 )
Insert the key into the ignition switch and pull it out at least 6 times .
Open and close the driver ’ s door .
Within 10 sec .
Within 10 sec .
The hazard warning flashers flash 3 times to indicate completion of the setting .
Your SUBARU dealer can perform the above procedure for you .
& Selecting Hazard Warning Flasher Operation s02ae26
Using the hazard warning flasher , the system will give you a visible signal when the doors are locked or unlocked . If desired , you can turn the hazard warning flashers off by operating the center information display . For details , refer to “ Car settings ” FP202 ( 11.6-inch display models ) or “ Vehicle setting icons ” FP220 ( dual 7.0-inch display models ). The setting can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
& Vehicle Finder Function s02ae05
Use this function to find your vehicle parked among many vehicles in a large parking lot . Provided you are within 30 feet ( 10 meters ) of the vehicle , pressing the “ ” button three times in a 5-second period will cause your vehicle ’ s horn to sound once and its hazard warning flashers to flash three times .
NOTE
If the interval between presses is too short when you press the “ ” button three times , the system may not respond to the signals from the remote transmitter .
& Sounding a Panic Alarm s02ae06
To activate the alarm , press the “ PANIC ” button once .
The horn will sound and the hazard warning flashers will flash .
To deactivate the panic alarm , press any button on the remote transmitter . If a button on the remote transmitter is not pressed , the alarm will be deactivated after approximately 30 seconds .
& Replacing the Battery s02ae08
Refer to “ Replacing Battery ” FP498 .
& Replacing Lost Transmitters s02ae09
If you lose a transmitter or want to purchase additional transmitters ( up to four or seven can be programmed ), you should re-program all your transmitters for security reasons . The maximum number of transmitters that can be registered for use with one vehicle is as follows .
. Four ( models without “ keyless access with push-button start system ”)
. Seven ( models with “ keyless access with push-button start system ”)
For details , contact your SUBARU dealer and have the transmitters programmed into the remote keyless entry system .
& Certification for Remote Keyless Entry System s02ae18
. U . S . -spec. models FCC ID : CWTB1G496 FCC ID : CWTD1G141
CAUTION
FCC CAUTION
Changes or modifications not expressly approved by the party re-
2
Keys and Doors
– CONTINUED –