124
Remote Keyless Entry System
If desired , you can turn the hazard warning flashers off by operating the center information display . For details , refer to “ Car settings ” FP202 ( 11.6- inch display models ) or “ Vehicle setting icons ” FP220 ( dual 7.0-inch display models ). The setting can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
& Locking the Doors s02ae01
Press the “ ” button to lock all the doors ( including the rear gate and the fuel filler lid ). An electronic chirp will sound once and the hazard warning flashers will flash once .
If any of the doors ( including the fuel filler lid ) is not fully closed , the following will occur to alert you that the doors are not properly closed .
. An electronic chirp sounds five times .
. The hazard warning flashers flash five times .
When you close the door , it will automatically lock and then the following will occur .
. An electronic chirp sounds once .
. The hazard warning flashers flash once .
& Unlocking the Doors s02ae02
Press the “ ” button to unlock the driver ’ s door and fuel filler lid . An electronic chirp will sound twice and the hazard warning flashers will flash twice . To unlock all the doors and the rear gate , briefly press the “ ” button again within 5 seconds .
NOTE
If the interval between the first and second presses of the “ ” button for unlocking all the doors is extremely short , the system may not respond .
& Opening the Rear Gate s02ae13
Press the “ ” button to unlock the rear gate . An electronic chirp will sound twice and the hazard warning flashers will flash twice .
This operation setting can be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
& Setting Audible Signal Operation s02ae07
Using an electronic chirp , the system will give you an audible signal when the doors lock and unlock .
Models with “ keyless access with push-button start system ”:
If desired , you can turn the audible signal off by operating the center information display . For details , refer to “ Car settings ” FP202 ( 11.6-inch display models ) or “ Vehicle setting icons ” FP220 ( dual 7.0- inch display models ). Furthermore , the volume setting of the audible signal can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
Models without “ keyless access with push-button start system ”:
Perform the following steps to deactivate the audible signal . Take the same steps to restore the function .