Light Control Switch 233 |
||||||
|
. The light sensitivity of the auto on / off headlights can be changed by operating the center information display . For details , refer to “ Car settings ” FP203 ( 11.6-inch display models ) or “ Vehicle setting icons ” FP221 ( dual 7.0-inch display models ). Also , the setting can be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
“ ” position :
Instrument panel illumination , parking lights , front side marker lights , rear side marker lights , tail lights and license plate lights are on .
|
“ ” position :
Instrument panel illumination , headlights , parking lights , front side marker lights , rear side marker lights , tail lights and license plate lights are on .
! Auto-on / off wiper-linked headlights s03ah0106
While the light control switch is in the “ AUTO ” position , the headlights will automatically turn on when the windshield wipers operate several times . The headlights will automatically turn off approximately 1 minute after the wiper stops .
The ON / OFF setting of this function can be changed by operating the center information display . For details , refer to “ Car
|
settings ” FP203 ( 11.6-inch display models ) or “ Vehicle setting icons ” FP221 ( dual 7.0-inch display models ). Also , the setting can be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
! Welcome lighting function s03ah0103
The welcome lighting function turns on the low beam headlight for smooth approaching to or exiting from the vehicle at night or in a dark place .
The function is activated while all of the following conditions are met .
. The light control switch is in the “ AUTO ” position .
. It is dark enough to turn on the auto on / off headlights .
NOTE
If the engine is turned off after turning off the light switch , the welcome lighting function may not operate ( for Canada models ).
! When approaching s03ah010301
While the welcome lighting function is activated , the low beam headlights will automatically illuminate when unlocking the doors by using the remote keyless entry system .
The low beam headlights will remain
|
illuminated for 30 seconds * 1 and then turn off . However , if any of the following operations is done , the low beam headlights will turn off .
. The doors are locked .
. The light control switch is turned to a position other than “ AUTO ”.
! When exiting s03ah010302
While the welcome lighting function is activated , the low beam headlights will remain illuminated even when either of the following operation is done .
. The push-button ignition switch is turned to the “ OFF ” status ( models with “ keyless access with push-button start system ”).
. The key is pulled out from the ignition switch ( models without “ keyless access with push-button start system ”).
The low beam headlights will turn off under any of the following conditions .
. 3 minutes have passed since the low beam headlights were illuminated by the welcome lighting function .
. 30 seconds have passed since the door is opened and closed .* 1
. The light control switch is turned to a position other than “ AUTO ”.
|
3
Instruments and Controls
|
||
– CONTINUED – |