1-18
Seat , seatbelt and SRS airbags / Seatbelts
WARNING
. Be sure to fasten both tongue plates to the respective buckles . If the seatbelt is used only as a shoulder belt ( with the connector ’ s tongue plate not fastened to the connector ’ s buckle on the right-hand side ), it cannot properly restrain the wearer in position in an accident , possibly resulting in serious injury or death .
. The head restraint is not intended to be used at the lowest position . Before sitting on the seat , raise the head restraint to the extended position . Otherwise , in an accident , serious injury or death could result .
1 . Raise the head restraint to the extended position . Do not remove the head restraint .
3 . After drawing out the seatbelt , pass it through the belt guide as follows : First insert one edge of the belt into the open gap in the belt guide ; then slide the rest of the belt in , so that the whole belt fits inside .
2 . Remove the tongue plate from the belt holder on the right side of the cargo area and pull out the seatbelt slowly .