7-60
Starting and operating / BSD / RCTA
BSD / RCTA OFF indicator( type B)
If the BSD / RCTA OFF switch is pressed, the BSD / RCTA OFF indicator appears on the combination meter, and the BSD / RCTA is deactivated.
Press the switch again to activate the BSD / RCTA. The BSD / RCTA OFF indicator will disappear.
When this occurs, the BSD / RCTA approach indicator light on the side of the rearview mirror illuminates for a few seconds and then turns off.
NOTE
. In the following cases, the system may not operate properly due to blocked radar waves. Press the BSD / RCTA OFF switch to deactivate the system.
– When towing a trailer – When a bicycle carrier or other carrier item is fitted to the rear of the vehicle – When using a chassis dynamometer or free roller device, etc. – When running the engine and making the wheels rotate while lifting up the vehicle. If the ignition switch is turned to the“ LOCK”/“ OFF” position, the last known status of the system is maintained. For example, if the ignition switch is turned to the“ LOCK”/“ OFF” position with the BSD / RCTA deactivated, the BSD / RCTA will remain deactivated the next time the ignition switch is turned to the“ ON” position.
& Certification for the BSD / RCTA
S07BM06
! U. S.-spec. models
S07BM0601
FCC ID: OAYSRR3A CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:( 1) This device may not cause harmful interference, and( 2) this device must accept any interference received, including interference that may cause undesired operation.