Subaru Crosstrek Manuals 2019 Crosstrek Owner's Manual | Page 133

2-26 Keys and doors/Alarm system When the system is in surveillance state, the security indicator light will then flash slowly (twice approximately every 2 sec- onds), indicating that the system has been armed for surveillance. NOTE . The system can be armed even if the windows and/or moonroof are open. Always make sure that they are fully closed before arming the system. . The 30-second standby time can be eliminated if you prefer. Have it per- formed by your SUBARU dealer. . If any of the following actions is done during the standby period, the system will not switch to the surveil- lance state. – Doors (including the rear gate) are unlocked using the access key fob/remote transmitter. – Doors (including the rear gate) are unlocked using the keyless access function (models with “key- less access with push-button start system”). – Any door (including the rear gate) is opened. – The ignition switch is turned to the “ON” position (models without “keyless access with push-button start system”). – Push-button ignition switch is turned to the “ACC” position (mod- els with “keyless access with push- button start system”). & Disarming the system S02AF05 Perform either of the following procedures. . Briefly press a button (for less than 2 seconds) on the access key fob/remote transmitter. . Carry the access key fob and perform either of the following procedures (models with “keyless access with push-button start system”). – Grip the front door handle. – Press the rear gate opener button. – Unlock using the PIN code access. The flashing of the security indicator light will then change slowly (once approxi- mately every 3 seconds from twice ap- proximately every 2 seconds), indicating that the alarm system has been disarmed. ! Emergency disarming S02AF0501 If you cannot disarm the system using the access key fob/transmitter (i.e. the trans- mitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the access key fob/ remote transmitter. The system can be disarmed if you turn the ignition switch from the “LOCK”/“OFF” to the “ON” position with a registered key/ access key fob. NOTE For models with “keyless access with push-button start system”, if the ac- cess key fob battery is discharged, perform the procedure described in “Switching power status” F9-18. In such a case, replace the battery im- mediately. Refer to “Replacing battery of access key fob” F11-44. & Alarm system setting S02AF11 To change the setting of your vehicle’s alarm system for activation or deactiva- tion, do the following. 1. Disarm the alarm system. Refer to “Disarming the system” F2-26. 2. Sit in the driver’s seat and shut all doors, rear gate and engine hood. 3. Turn the ignition switch to the “ON” position. 4. Hold down “ ” of the driver’s power door locking switch, open the driver’s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.