3-6
Instruments and controls/Meters and gauges
The display can be switched as shown in
the following sequence by pressing the
trip knob.
has been set for activation “ ” at
the time of shipment from the factory.
. It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the “ON” position. Change the setting
when the ignition switch is in the “OFF”
or “ACC” position.
& Meter/Gauge needle illumination setting
It is possible to activate or deactivate the
illumination of the meter needles and
gauge needles.
When the setting is activated or deactivated, the meter needles and gauge
needles illuminate and turn off as follows.
*1: They cannot be displayed when the
ignition switch is in the “ON” position.
*2: Displayed only for models with BSD/
RCTA.
To change the current setting, press and
hold the knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle’s initial movement
setting of the meter/gauge needles
Activated:
The needles will illuminate and turn off
after approximately 20 seconds when the
driver’s door is opened while the ignition
switch is in the “OFF” position.
The illumination of the needles gradually
turns off after the ignition switch is turned
from the “ON” position to the “OFF”
position.
Deactivated:
The needles will not illuminate when the
driver’s door is opened while the ignition
switch is in the “OFF” position.
The illumination of the needles turns off
immediately after the ignition switch is
turned from the “ON” position to the “OFF”
position.
NOTE
. Even during the illumination after
the driver’s door is opened, if the
ignition switch is turned to the “ON”
position, the combination meter will
illuminate as usual.
. If the doors are locked by the remote
keyless entry system or keyless access function during the illumination
after the driver’s door is opened, the
illumination will be turned off.
. Even while the illumination gradually turns off after the ignition switch is
turned to the “OFF” position, if the
ignition switch is turned to the “ON”
position, the combination meter illuminate as usual.