3-92
Instruments and controls/Light control switch
! Sensor for the auto on/off headlights (if equipped)
& High/low beam change
(dimmer)
The sensor is on the instrument panel as
shown in the illustration.
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “ ” on the combination meter is also on.
To switch back to low beam, pull the lever
back to the center position.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light correctly and the auto on/off headlights
may not operate properly.
& Headlight flasher
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the lighting switch is in the
“ ” (off) position.
When the headlights are on high beam,
the high beam indicator light “ ” on the
combination meter also illuminates.