Instruments and controls/Light control switch
“
” position: auto on/off headlights (if
equipped)
When the ignition switch is in the “ON”
position, the instrument panel illumination,
headlights, parking lights, front side marker lights, rear side marker lights, tail lights
and license plate lights are automatically
on or off depending on the level of the
ambient light.
“ ” position
The headlights are all off.
NOTE
The sensitivity of the auto on/off headlights can be changed by a SUBARU
dealer. Consult your SUBARU dealer
for details. Also, for models with a multi
function display, the setting can be
changed using the display. For details,
refer to “Auto light sensor sensitivity
setting” F3-84.
! Welcome lighting function (if
equipped)
The welcome lighting function turns on the
low beam headlight for smooth approaching to or exiting from the vehicle at night or
in a dark place.
The function is activated while all of the
following conditions are met.
. The light control switch is in the
3-91
“AUTO” position
. It is dark enough to turn on the auto on/
off headlights
. The key is pulled out from the ignition
switch (models without “keyless access
with push-button start system”)
When approaching:
While the welcome lighting function is
activated, the low beam headlights will
automatically illuminate when unlocking
the doors (for 5-door, including the rear
gate) by using the remote keyless entry
system.
The low beam headlights will turn off
under any of the following conditions.
. 3 minutes have passed since the low
beam headlights were illuminated by the
welcome lighting function.
. 30 seconds have passed since the
door is opened and closed.*1
. The light control switch is turned to a
position other than “AUTO”.
. The locking procedure is performed
twice. When performing the unlocking
procedure after performing the locking
procedure, perform the locking procedure
twice again.
The low beam headlights will remain
illuminated for 30 seconds*1 and then turn
off. However, if any of the following
operations is done, the low beam headlights will turn off.
. The doors are locked.
. The light control switch is turned to a
position other than “AUTO”.
. The ignition switch is turned to the “ON”
position.
When exiting:
While the welcome lighting function is
activated, the low beam headlights will
remain illuminated even when either of the
following operation is done.
. The push-button ignition switch is
turned to the “OFF” status (models with
“keyless access with push-button start
system”)
*1: The setting for the period of time in which
the low beam headlights remain on by the
welcome lighting function can be changed by a
SUBARU dealer. Contact your SUBARU dealer
for details.
– CONTINUED –