BRZ _ U. book 181 ページ 2024 年 6 月 14 日 金曜日 午前 9 時 14 分
to the“ AUTO” position and push the signal lever forward( high beam position).
2. After the high beam assist indicator on the combination meter will illuminate, turn the ignition switch to the“ OFF” position.
3. Turn the ignition switch to the“ ON” position and within approximately 15 seconds, press the“”( following distance setting) switch more than 10 times consecutively.
When the sensitivity of the high beam assist function is lowered, the high beam assist indicator light“” on the combination meter display( color TFT) will flash. NOTE
� The sensitivity of the high beam assist function cannot be lowered in the following conditions.- Cruise control or Adaptive Cruise Control indicator is illuminated.- The EyeSight warning indicator( yellow) is illuminated � The sensitivity of the high beam assist function returns to normal level the next time the ignition switch is turned to the“ OFF” position and the engine is restarted.
▼ How to change the headlight mode manually
Change to the low beam: � Set the light control switch to“”.
� Pull the lever while the high beam is turning on and release it.
Change to the high beam: Push the lever forward and release it.
At this time, the high beam assist function will turn off, the high beam assist indicator will turn off and the high beam indicator light will turn on.
NOTE
� After manually changing the headlight mode to the high beam, if you turn on the high beam assist function, push the lever forward and release it. � When manually changing the headlight mode to the high beam, if you turn the light control switch to the“” position, the parking lights, side marker lights, tail lights and license plate lights will turn on.
▼ Tips for the high beam assist system
� The high beam assist function recognizes the condition surrounding the vehicle based on the brightness of illumination ahead of your vehicle, etc. There-