BRZ _ U. book 118 ページ 2024 年 6 月 14 日 金曜日 午前 9 時 14 分
118
Windows every 3 seconds), indicating that the alarm system has been disarmed.
▼ Emergency disarming
If you cannot disarm the system using the access key fob, you can disarm the system without using the access key fob.
The system can be disarmed if you turn the ignition switch from the“ OFF” position to the“ ON” position.
NOTE
If the access key fob battery is discharged, perform the procedure described in " Switching Power Status " �P322. In such a case, replace the battery immediately. Refer to " Replacing Battery of Access Key Fob " �P374.
■ Alarm System Setting
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to " Disarming the System " �P117.
2. Sit in the driver’ s seat and shut all doors.
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
Setting status
Combination meter display( color TFT)
Horn
Activate |
AL ON |
Once |
Deactivate |
AL OFF |
Twice |
NOTE
You may have the above setting change done by your SUBARU dealer.
■ If You Have Accidentally Triggered the Alarm System
▼ To stop the alarm Do any of the following operations:
� Press unlock button on the access key fob.
� Turn the push-button ignition switch to the“ ACC” position.
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.
2
N
� c c o o