Seats 49 |
|||
! Height adjustment |
S01AQ040101 |
! Angle adjustment |
S01AQ040102 |
|
1 Head restraint 2 Release button
To raise : Pull the head restraint up . To lower :
Push the head restraint down while pressing the release button on the top of the seatback .
To remove :
While pressing the release button , pull out the head restraint .
To install :
Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks . Press and hold the release button to lower the head restraint .
|
Each head restraint should be adjusted so that the center of the head restraint is closest to the top of the occupant ’ s ears .
NOTE
When the head restraint cannot be pulled out or installed due to insufficient clearance between the head restraint and the roof , tilt the seat and then perform the installation and removal tasks .
|
The angle of the head restraint can be adjusted in several steps . While maintaining a suitable driving posture , adjust the head restraint to a position where the back of your head is as close to the head restraint as possible .
To tilt :
Tilt the head restraint by hand to the preferred position . A click will be audible when the head restraint is locked .
To return :
Tilt the head restraint once as far forward as it can go . The head restraint will automatically return to the fully upright position . Then , adjust the head restraint again to the preferred angle .
|
Seat , seatbelt and SRS airbags |
|||||
– CONTINUED – |