Illumination brightness control 169 |
|||||||
|
& Combination meter settings
S03AD16
Meter settings can be set on the center information display. For details, perform the procedures described in“ General settings” FP208.
|
3-4. Illumination brightness control |
S03AJ
The illumination brightness of the combination meter and center information display dims under the following conditions.
. The light switch is in the“” or“” position when the ambient light is dark.
. The light control switch is in the“ AUTO” position and the headlights illuminate automatically.
You can adjust the illumination brightness for better visibility.
|
NOTE
. When the control dial is turned fully upward, the illumination brightness becomes the maximum and the automatic dimming function does not work at all.
. The brightness setting is not canceled even when the ignition switch is turned to the“ OFF” position.
& Auto dimmer cancel function
S03AJ01
When the ambient light is bright, the illumination brightness is set to the maximum regardless of the position of the control dial. In this case, you cannot adjust the illumination brightness by using the control dial. When the ambient light is dark, you can dim the illumination brightness as described above.
The operational / non-operational setting and sensitivity of the auto dimmer cancel function can be changed by your SUBARU dealer. Contact your SUBARU dealer for details.
|
Instruments and controls |
|||
To brighten, turn the control dial upward. To darken, turn the control dial downward. |