144
Alarm system
Always make sure that they are fully closed before arming the system.
. When arming the system, if any of the doors or the rear gate is not fully closed, an electronic chirp sounds five times and the hazard warning flashers flash five times to alert you that the doors( or the rear gate) are not properly closed. When you close the door, doors will automatically lock and the system will automatically arm in 30 seconds.
. The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer.
. If any of the following actions is done during the standby period, the system will not switch to the surveillance state. – Doors( including the rear gate) are unlocked using the access key fob.
– Doors( including the rear gate) are unlocked using the keyless access function.
– Any door( including the rear gate) is opened.
– Push-button ignition switch is turned to the“ ACC” position.
& Disarming the system
S02AF05
Perform either of the following procedures.
. Briefly press a button( for less than 2 seconds) on the access key fob.
. Carry the access key fob and perform either of the following procedures. – Grip the front door handle. – Press the rear gate opener button. – Unlock using the PIN code access.
The flashing of the security indicator light will then change slowly( once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed.
! Emergency disarming
S02AF0501
If you cannot disarm the system using the access key fob( i. e., the access key fob broken or the access key fob battery is too weak), refer to“ Switching power status” FP461.
NOTE
If the access key fob battery is too weak, replace the battery immediately. Refer to“ Replacing battery of access key fob” FP512.
& Alarm system setting
S02AF11
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to“ Disarming the system” FP144.
2. Sit in the driver’ s seat and shut all doors, the rear gate and engine hood.
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
Setting status
Combination meter display
Horn
Activate |
AL ON |
Once |
Deactivate |
AL OFF |
Twice |
NOTE
You may have the above setting change done by your SUBARU dealer.