Light control switch 235 |
||||||||
|
. When the EyeSight system is malfunctioning or temporarily stopped .
NOTE
. Do not overestimate the capacity of the high beam assist function . The driver always has the responsibility to understand the surrounding situation , to drive safely , and to change the headlight mode manually if necessary .
. The factory setting ( default setting ) for this function is set as “ operational ”. This setting can be changed to OFF ( non-operation ) at SUBARU dealers . For more details , contact a SUBARU dealer .
! How to use the high beam assist function
S03AH0701
The high beam assist function will be activated when all the following conditions are met .
. The light control switch is in the “ AUTO ” position and the low beam headlights are on automatically .
. The turn signal lever is pushed forward .
|
High beam assist indicator light
When the high beam assist function is activated , the high beam assist indicator light on the combination meter will illuminate .
NOTE
If the high beam assist function is malfunctioning or temporarily stopped , the headlight will be fixed at low beam .
|
! How to temporarily lower the sensitivity of the high beam assist function
S03AH0704
The sensitivity of the high beam assist function can be lowered by performing the following operations .
1 . Before turning the ignition switch to the “ ON ” position , set the light control switch to the “ AUTO ” position and push the signal lever forward ( high beam position ).
2 . Turn the ignition switch to the “ ON ” position and within approximately 15 seconds , press the “ / ” ( following distance setting ) switch more than 10 times consecutively .
|
When the sensitivity of the high beam assist function is lowered , the high beam assist indicator light “ ” on the combination meter will flash .
NOTE
. The sensitivity of the high beam assist function cannot be lowered in the following conditions . – The Cruise Control indicator is illuminated . – The EyeSight warning indicator
( yellow ) is illuminated . . The sensitivity of the high beam
|
Instruments and controls |
||||
– CONTINUED – |