Service Center Solahart (081313462267) water heater | Page 19

33-1197 Solahart Owner‟s Manual – Thermosiphon Systems - Revision H – Nov 2013

17

FITTING THE PIPE SHROUD COVER

The Pipe Shroud Cover contains a number of preformed cut outs.
Each cut-out can be removed using a pair of snips
by following the preformed cut-out lines.
Remove only the necessary cut-outs to suit the
installation.
OTP Expansion
Caution: Practise safe working procedures when
vessel flexible
using the snips and care is to be taken to avoid
hose cut out
potential injury from cut edges.
Additional cut outs other than those moulded into
pipe work
the cover should not be made.
cut outs
To fit the Pipe Shroud Cover to the jacket end after the
plumbing pipe work and electrical connection has been
made:
Position the cover so the five connection points
line up over the five screw penetrations in the tank
end cover.
Screw in the five screws provided, taking care not
to over tighten the screws.
Only use the screws provided.

electrical and
pipe work
cut out

additional
pipe work
cut outs

Note: The Pipe Shroud Cover when fitted must be flush with the jacket end of the solar storage tank. There is to be no
distortion of the cover due to poorly installed pipe work. Correct the pipe work if the cover does not fit correctly.