www. refrigerationandaircon. co. za 49
CERTIFICATION
NOT ALL SMOKE FAN CERTIFICATES ARE EQUAL – HERE ' S WHAT FIRE ENGINEERS SHOULD BE CHECKING
Every fire engineer specifying a smoke extract fan knows to ask for EN 12101-3 certification. voices
What ' s less well understood is that not all documents labelled‘ certification’ carry the same weight. A manufacturer may hand over a quality management certificate, a type test report, or a genuine product certificate – and confusing the three can put a building ' s life-safety system on paper only.
With smoke fans now a routine specification item across shopping centres, basements, tunnels and high-rise car parks, it ' s worth revisiting exactly what EN 12101-3 certification requires, who is entitled to issue it, and what questions should be asked before a product is accepted onto a fire safety specification.
WHY CERTIFICATION INTEGRITY MATTERS A smoke fan motor operates in one of the most demanding environments an item of building services equipment will ever face – extracting superheated gases during a live fire event, at the exact moment building occupants are relying on it to keep an escape route clear. EN 12101-3 exists because that environment cannot be replicated on a drawing board or verified by component data sheets alone.
The standard requires the complete fan assembly – motor, impeller, casing, bearings and seals – to be physically tested together, at the rated temperature, for the rated duration. No individual component certificate, however credible the issuing body, substitutes for a whole-assembly test.
Just as important, a one-off type test is not enough on its own. The standard requires ongoing production surveillance, to confirm that every unit leaving the factory floor still matches the prototype that was originally tested. A certificate resting on a lapsed annual audit is no longer in good standing – even if the original type test remains technically valid.
TEMPERATURE CLASSIFICATIONS AT A GLANCE EN 12101-3 fans are rated F200, F300 or F400, according to the temperature and duration they ' re proven to survive:
RACA Journal I November 2026
Class Temperature Duration Typical application
F200 200 ° C 120 min General commercial buildings, low fireload environments
F300 300 ° C 60 min Car parks, shopping centres, standard commercial buildings
F400 400 ° C 120 min High-risk environments, tunnels, basements, high fire-load buildings
Classifications are discrete: ratings cannot be interpolated, combined or uprated. A motor certified at 400 ° C cannot be specified into a 410 ° C application- the certified temperature is the absolute maximum, not a guideline.
THE CERTIFICATION CHAIN: THREE STEPS, NOT ONE EN 12101-3 certification sits under the EU Construction Products Regulation( CPR) at AVCP System 1 – the highest level of thirdparty oversight the CPR provides. It is not a single event but a chain of evidence, and all three links must be in place for the certificate to mean anything.
• Type test – the complete fan assembly is physically tested at the declared temperature for the declared duration by an accredited test facility. This produces a type test report, which on its own is not a product certificate.
• Initial factory inspection – a notified body inspects the manufacturing facility and its Factory Production Control( FPC) system, confirming the manufacturer can consistently reproduce the tested prototype. Only then can a certificate of constancy of performance be issued.
www. refrigerationandaircon. co. za 49