Multifunction Digital Heat Press Machine Operating Instructions 黄色把手新款Multifunction Digital Heat Press Machine Ope | Page 3

OPERATING INSTRUCTIONS
 CHECK the correct voltage before using the machine. Be SURE to operate with reliable
grounded protection connections!
 TURN OFF the machine, and then DISCONNECT the power-supply before replacing the heat
units. DO NOT forget to wearing insulated gloves if the unit is still under high-temperature.
 AVOID prolonged burning of the heating parts. If not turning the power off, please place a hot
stamping replacement (it could be a scrap and can be used repeatedly). AVOID damaging the
heating units with sharp parts of the stamping object.
 AVOID touching the heating units and the compression spring without protection in case of
potential damage of body during use.
 If it’s hard to pushing the grasp, please adjust the rotation lock screw in order to reduce the
pressure of compression spring. Or, it will damage to the strength of the machine.
 Before lifting the machine, please lock the machine head by rotation lock screw and loosen the
handle (don’t screw the rotation lock screw too tight). Besides, do not put down the machine
beyond the limit. When meeting the falling limit, you can feel an obvious pressure on the
swiveling pressure adjustment wheel.
 Keep children away from the machine!!!
 DO NOT attempt to press products that are not intended for normal heat transfer. Baking pads
should be avoided of empty burning.
I. Preparation before Using:
1. Check the connection between power plug and electrical socket of electric cabinet. Be sure to
operate with safe ground wire!!!
2. Heat press element must be securely plugged into the machine before you switch the machine
on. Plug your electrical cord into the machine. Plug electrical socket into wall plug. Turn the
power on by flipping the On/Off Switch on. (Nominal voltage: 110V, Max. input power: 1400W)
3. Put in the object going to be shaped, close up the handle and rotate the adjusting screw to get a
proper pressure (the pressure of the mug press unit is a screw.)
4. Turn on the power switch, and the instrument board will display the temperature.