KL-TECH s.r.o | www.klte.cz
TECHNICAL INFORMATION
MACHINING RECOMMENDATIONS
Stainless Steel
V C
Stainless Steel
Exotic Material
In machining stainless steel, please verify and respect the cutting speed
recommended for the insert as there is a tendency to machine at speeds that are
too low.
In machining stainless steel or exotic materials, P geometry inserts (CNMP, TNMP,
WNMP) and NX chipbreakers are recommended as first choice.
NX-CNMP-TNMP-WNMP
Exotic Material
Verify
!
In machining exotic materials, it is important to verify cutting conditions of the
specific insert.
Cutting Conditions
CNMP
TNMP
WNMP
Feed x d.o.c.
=
Amax
V C
Productivity
318
P geometry inserts (CNMP, TNMP, WNMP) are not recommended
when machining with interrupted cut.
It is important to verify and respect Amax, which is the maximum chip section.
Feed x d.o.c. must be lower than the number noted as Amax.
To increase machining productivity, it is recommended to increase speed (Vc)
while respecting chip size calculation.