IN1060SC | Page 3

Following steps are for soft close .

100SD / 134F / 138F / 2610F Sliding Door Instructions :

Minimum Door Thickness 1 " ( 25mm ) Soft Close or Soft Open only , Minimum Door Width 18 " ( 457mm ). Soft Close and Soft Open , Minimum Door Width is 24 " ( 610mm ).
Following steps are for soft close .
HANGER IF TRACK
LOCK

1 UNLOCK

TABS

1 2

2

3

INSERT

4

ATTACH
1125
Engage Soft Close Dampener by pushing Dampener trigger toward 3 Wheel Roller .
2 " ( 51mm )

3

2 " ( 51mm )
1121
IMPORTANT MUST BE ENGAGED
NO
SHOWN IN " ENGAGED " POSITION

5

INSERT 1060 " ENGAGED " POSITION

6

INSERT
1060 Actuator Arm into track , with back of Actuator Arm 1-1 / 2 " ( 38mm ) from end of track , ( 18-24 " doors : Actuator would be flush with end of track ). HAND TIGHTEN ( do not use power drill ) Actuator Arm on track legs . Check to make sure Arm remains straight in track .
1-1 / 2 " ( 38mm )

7

LOCK
INSTALL track and hang door .

8 SLOWLY

LOCK slide door toward Jamb , checking to make sure door touches Jamb , if not . Slide door away from Jamb and readjust Actuator Arm . Slowly close door again , checking to make sure soft close is working properly . Once confirmed , begin using door normally .