Following steps are for soft open . Skip steps 1-3 if new installation .
IF FRAME
CUT ACCESS HOLE
HANGER
1
UNLOCK
3
CHECK to make sure all track screws are flat against track . DISASSEMBLE ACTUATOR ARM , ( with backside of arm facing pocket ), insert arm , bumper and lock nut into track and reassemble . Slide assembly into pocket until backside of Actuator Arm is 2-1 / 4 " ( 57mm ) plus the finish Split Jamb thickness from the rough stud . Example 2-1 / 4 " ( 57mm ) + 3 / 4 " ( 19mm ) Finish Jamb = 3 " ( 76mm ). Hand tighten Actuator Arm ( do not use power drill ). Check to make sure Arm remains straight in track .
4
IF NEW INSTALLATION 3 " ( 76mm )
5 6
Engage Soft Close Dampener by pushing Dampener trigger toward 3 wheel roller .
ROUGH STUD
Remove Bracket , Install Actuator Arm , Reattach Bracket . ATTACH
5
2-3 / 4 " ( 70mm )
LOCK TABS
2-3 / 4 " ( 70mm )
1121
IMPORTANT MUST BE ENGAGED
NO
SHOWN IN " ENGAGED " POSITION
7
6A
|
INSERT 1060
6B
|
6C |
8 |
INSERT 1125 |
LOCK
10 11
" ENGAGED " POSITION HANG DOOR .
6D
LOCK
SLOWLY slide door into pocket , checking to make sure door opens flush with Split Jamb , if not , slide door out of pocket and readjust Actuator Arm . Slowly open door again , checking to make sure soft close is working properly . Once confirmed , begin using door normally .
PATCH the wall .
9