Field Installation and Service Manual IMS124 | Page 3

1.3 Use the door hardware drill jig to mark the door with the exact location for the door pulls. Score the door with the drill bit while the jig is in place. Complete drilling the hole with the jig removed. This will help increase the life of the jig. Typical Door Hardware Drill Pattern For Base, Vanity, Desk and Lower Tall Cabinet Doors 2-1/2” CL Second Hole if Needed CL 2-1/2” For Wall and Upper Tall Cabinet Doors 1.4 For drawers, locate the center of the drawer face and index the center of the jig on that point. Choose the correct row of holes on the jig to center the hole in the height of the drawer face. ©2017 PCS Professional Cabinet Solutions. All Rights Reserved. 124 1.5 If you do not have a jig to mark the doors and draw- ers, a typical drill pattern for a door is centered on the rail of the door and down starting 2-1/2” from the top edge for base doors and 2-1/2” up from the bottom for wall cabinet doors. Section 1: IMS 124 3