Field Installation and Service Manual IMS115 | Page 6

Step 5
5.1
Make Contact
Carefully fold the hinged piece into place.
Be careful not to allow the glued skin to come into contact with any other glued surface until it is exactly in
place. It will adhere to the fi rst glued surface it touches, and can be easily damaged if that bond has to be
adjusted.
5.2
This glue will tack immediately,
but full bond is only achieved by apply-
ing pressure to the two surfaces.
Place pressure on the piece with a
roller or a wood block and a soft rag to
set the bond. Begin in the center and
work out to the sides and corners, until
every inch of the surface has been
bonded.
The bond is most critical at the perim-
eter of the panel being skinned. Pay
extra attention to make sure that the
perimeter has a complete bond.
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 115
6