Field Installation and Service Manual IMS113 | Page 3

1.3
When possible, make these cuts with a table saw by elevating the blade into the cut from the back
(Blind Cut).
113
Use caution not to over cut the corners, doing so can severely weaken the strength of the frame or risk contacting as-
sembly screws in the frame with the saw blade.
1.4
Finish the corners with a jig saw.
Use additional masking tape if needed
to protect the frame face from damage
caused by the saw.
Pre-color Inside
Edges of Seam
if Visible
1.5
To decrease the size of an opening
Cut and fi t matching material snugly to decrease a standard opening.
Use solid fi ller stock for this purpose.
Pre-color the inside seams of the material before joining the pieces if
the seam will not be covered completely by the appliance trim.
©2017 PCS Professional Cabinet Solutions. All Rights Reserved.
Section 1: IMS 113
3